Wear minimal clothing (ie. T-Shirt, shorts, bathing suit) at the time of measuring. All measurements must be taken with a soft tape measure pulled snug but not tight. Stand straight, looking forward with your feet flat on the floor. It is best to have help taking the measurements, in order to remain in the optimal measuring stance.
WEIGHT: As close as you can accurately
HEIGHT: From the top of your head to the floor
Wear minimal clothing (ie. T-Shirt, shorts, bathing suit) at the time of measuring. All measurements must be taken with a soft tape measure pulled snug but not tight. Stand straight, looking forward with your feet flat on the floor. It is best to have help taking the measurements, in order to remain in the optimal measuring stance.HEIGHT: From the top of your head to the floor
To complete your exposure protection system, it is important to have the proper fitting boot. One that bunches or causes discomfort can be an unnecessary distraction during your adventure.
Your suit may fit perfectly but sometimes little things can affect a diver’s experience. A hood that bunches or lets water in is just enough discomfort to change the focus of a dive. Our hoods are designed with anatomical fit so it is important to measure for the perfect fit.
FOREHEAD: Start in the center, front and measure around the widest part.
NECK: Start in the center, front and measure around the middle of the neck.
To complete your exposure protection system, it is important to have the proper fitting gloves. Measure A & B as described and use the chart to determine your unisex size.
A: Palm Circumference
B: Palm Length
The Ocean Reef Aria range is available in a number of sizes to suit different ages and face shapes. The wide silicone seals means that each size can fit a wide range of users.
Refer to the size guide for visual measuring instructions but the measurements refer to the distance from the chin to the top of the nose in cm.
Adaptability- Face Seal
The patented bellows-type skirt with a “spring profile” has a large sealing surface (30-45 mm, double that of a conventional mask). The spring effect is achieved by a combination of the double “S” section and the inner support ribs, resulting in a comfortable fit and ample support. This allows the mask to “float” comfortably on the face. The face seal and strap concepts are OCEAN REEF patents.
The majority of the models may be supplied with two sizes: Small/Medium and Medium/Large. In order to determine whether a diver should wear a S/M or M/L mask, OCEAN REEF has designed a Mask Measuring Kit (code 33075).
The sizing and measuring system were designed in accordance with the official measuring procedure used in the Los Alamos Scientific Laboratory Charts at the SBCCOM Mask Fit Facility-Aberdeen Proving Ground (Maryland, USA). Before purchasing a mask, use the caliper to take two simple face measurements. Using the Full Face Mask Size Recommendation Chart, it is possible to evaluate the size category into which the measurements fall.
There are three different size categories on the chart: Small/Medium, Both, and Medium/Large. If the measurements fall within the both category, then the customer should technically be able to wear either size (MEDIUM/LARGE or SMALL/MEDIUM), and in that case they should try on a mask to select the best fit. Please note that the chart boundaries fade. The fading areas represent less common face measurements. It is very likely that a mask will still fit comfortably even if measurements are located in these fading areas.
When measuring yourself you need to measure the widest part of your chest, narrowest part of your waist, widest part of your hips and widest part of your thighs. VIEW GUIDE
Measure the circumference of your hand around your palm.
*Note: Size chart is not style specific. It is only offered as a rough guide for your convenience.
Note: when printing the file, set scaling to "none" in order to get an accurate measurement
Disclaimer: The Glove Size Chart has general guidelines only. Sizes are not guaranteed.